Form No. 3373-246 Rev A Spiker Greensmaster® 3300/3400 Series TriFlex™ Traction Unit Model No. 04723—Serial No. 312000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
Note: When the latches are properly locked a “click” can be heard and felt. 1 4. Insert the motor into the left side of the spiker unit (as viewed from the operator’s position), and pull the motor retaining bar on the spiker unit toward the motor until you hear an audible “click” from both sides of the motor (Figure 3). Installing the Spiker Units No Parts Required Procedure Park the unit on a level surface, set the parking brake, turn the ignition off, and remove the key. 1.
• When you reach the edge of the green, raise the spikers 1. Park the machine on a clean level surface, lower the spiker units to the ground until the suspension hydraulics are fully extended, stop the engine, set the parking brake, and remove the key from the ignition switch. 2. Push the motor retaining bar out of the slots on the motor towards the spiker unit and remove the motor from the spiker unit. before turning or stopping the machine. The spikers must be raised completely before making turns.
The Toro Total Coverage Guarantee A Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
