Operator's Manual
Position a spring scale on transport hook and lift
up. Tension necessary to lift gauge wheel off ground
should be 30-50 lbs.
If tension is not 30-50 lbs., adjustment is made by
tightening or loosening adjustment screw on
counterbalance spring.
Perform this procedure on both sides of sweeper.
Because of added weight of drive components,
the R.H. spring will require a tighter setting than the
L.H. spring.
(&
Flex tip reel should be adjusted so rake tips slightly
touch surface but do not penetrate turf. If rake tips
penetrate turf, improper debris pickup could result.
Position sweeper on a level surface.
Loosen locknut on depth adjustment bolt so it can
be turned.
(&30$
."*-32
Turn depth adjustment bolt until rake slightly
contacts top of turf grass. If a broom is installed, slight
contact should be made with surface. When broom is
operating, the contact width surface should be about
1" wide across entire length of broom.
(&30$
$/2' #)312(-& !.+2
Repeat procedure on opposite side of machine.
Retighten adjustment lock nut.
(&
For best debris pick up results, metal portion of front
flap should be vertical to ground.
Move flat lever forward to lower flat.
(&30$
3!!$0 %+ /
$2 + $#&$
Loosen jam nut on top of stop and rotate
adjustment bolt up or down until flap is vertical to
ground.
(&30$
#)312,$-2 !.+2
2./
Tighten jam nut to secure adjustment.
Flap may be positioned in raised position when
picking up large amounts of leaves.