Operator's Manual
+)63'
.65%* .'7'3
.65%* .'7'3 2+715 4*#(5
22.9 (13%' *'3'
17'3 2.#5'
! +)
Replace rubber flap when it becomes worn or
damaged.
!
*#0)' 36$$'3 (.#2 10 # (.#5 .'7'.
463(#%' #0& $.1%- 8*''.4 51 23'7'05
48''2'3 (31/ 31..+0) #+.63' 51 &1 41
/#9 3'46.5 +0 2'3410#. +0,639
Remove (10) capscrews, washers, and nuts
mounting flap and flap retainer.
+)63'
6$$'3 (.#2
.#2 3'5#+0'3
Replace with new rubber flap and fasten securely.
" ! +)
"
'(13' 3'/17+0) #09 &'$3+4 (31/ $.18'3
*164+0) &+4'0)#)' %.65%* &+4'0)#)'
&3+7' 4512 '0)+0'4 #0& /#-'
%'35#+0 #.. /17+0) 2#354 *#7' 45122'& 13
2'3410#. +0,639 /#9 1%%63
Make sure impeller has stopped rotating before
removing access plates.
Loosen (2) wing nuts securing access plate.
+)63'
%%'44 2.#5'
Swing access plate to one side allowing removal of
debris.
After debris has been removed, lower access plate
and secure with wing nuts. Repeat procedure on other
access plate.
!
Check condition and tension of belts after first day of
operation and every 200 operating hours thereafter.
/2'..'3 3+7' '.5 1&'. 10.9 +)
Check tension by depressing belt at mid span of
impeller and clutch pulleys with 3.8-5.2 lbs. of force.
Belt should deflect .53 in. If deflection is incorrect,
proceed to next step. If correct, continue operation.