Operator's Manual
!
To adjust drive chain tension:
Remove idler sprocket mounting capscrew.
Add or delete spacers behind idler sprocket
until upper drive sprocket and lower drive sprocket
properly aligned.
/-96+
6/:+ ).'/3
*1+6 7564)0+8
"55+6 *6/:+ 7564)0+8
4;+6 *6/:+3 7564)0+8
To increase chain tension push idler sprocket
toward chain. To decrease chain tension push idler
sprocket away from chain.
! Make sure all sprockets are in alignment.
Failure to do this could result in throwing of chains,
plugging sweeper and may result in personal injury.
%
4*+1 431= /-
Change gear box oil every 800 hours of operation .
Remove capscrews securing shield to gear box
and frame.
$
! ! $ $!
!& # , 7',+8=
7./+1*7 '6+ 6+24:+* ,642 7;++5+6 '3*
2'/38+3'3)+ /7 (+/3- 5+6,462+* 2'0+
796+ 93/:+67'1 )4951+6 /7 */7)433+)8+*
,642 56/2+ 24:+6 ! 7.',8
Place a pan on the ground beneath gear box.
Remove oil drain plug from bottom of gear box and
allow all oil to drain out.
/-96+
/11 519-(6+'8.+6
6'/3 519-
When all oil has drained out of gear box secure oil
drain
Remove oil fill plug/breather from top of gear box.
Fill gear box with 1-1/2 pints of 80 or 90 weight oil.
Insert plug in hole and secure.
% # 4*+1 431=
/-
Remove capscrews securing shield to gear box
and frame.
Remove (4) capscrews securing bottom of gear
box to gear box base plate.
/-96+
+'6 (4< ('7+ 51'8+
4951+6 7564)0+87
49(1+ )4951+6 ).'/3
"3/:+67'1 7.',8
Disconnect double coupler chain by removing clip
and pin and remove from coupler sprockets.