Operator's Manual
Attach capscrew and locknuts and hook up
springs.
'%2/$
.0"/$3 ,# *-"),21
-"),21
'%
Remove tine retainer and slide damaged tine out.
'%2/$
',%$/ .* 1$
',$ /$1 ',$/
',$
Bend new tine in half and slide into position.
Place tine bracket over curved end of tine and
fasten securely with capscrew and lockwasher.
'%
Remove brush from sweeper.
Loosen clamps with a allen wrench and remove
from brush halves.
'%2/$
* +.
Separate brush halves and discard damaged
section(s).
'%2/$
Install new brush section(s) by pushing together
and secure both ends with brush clamps. When ends
have been secured, fasten brush with remaining
clamps.
Park machine on a flat, level surface. Block other
tire to prevent accidental rolling or injury.
Place jack under frame or axle shaft behind wheel
and jack up wheel until it just contacts floor.
! " . "'14 &4#/ 2*'" ( ")
0&-2*# !$ 20$# 3&$, "& ,%',% 1'/$
Loosen all lug bolts and continue to jack up until
tire can be removed.
Reverse above procedure to install tire. Torque lug
bolts to 70 to 90 ft. / lbs.