Operator's Manual
"# $ "#!$#"
5*+2
Remove front and rear capscrews and
locknuts securing hitch tongue to frame (Fig. 2).
Raise or lower hitch tongue to position it
approximately level with prime move hitch and
secure with (2) capscrews and locknuts. The main
frame should be parallel with the ground surface
about 23-1/2" when attached to tractor.
/-;8+
/:). :54-;+ 5*+2
854: '*0;9:3+4: )'69)8+=
!+'8 '*0;9:3+4: )'69)8+=
Secure sweeper hitch tongue to prime mover hitch
with hitch pin and hair pin cotter.
Raise sweeper jack caster wheel tube up to frame
and fold handle down.
Store caster wheel in compartment on left side of
machine in front of hopper.
!## After first ten hours of operation,
re-tighten capscrews and locknuts securing hitch
tongue to sweeper.
# !% "# # !
%! # "# 5*+2 542?
!## Mating tractor must have the following
dimensions. Do not operate sweeper with tractor of
different dimensions.
/-;8+
A = 13-1/2" TO 14-l/2"
B = 2-3/4" TO 11-1/2''
C = 7-1/4" TO 17-1/4"
P.T.O. SHAFT
(540 RPM)
A
B
C
DRAW BAR
!## The distance (A" Figure 3) between the
hole in the tractor hitch and the point where the drive
shaft coupler attaches to the prime mover, P.T.O. shaft
must be 14'' plus or minus 1/2". If 14" is not evident, an
adjustment to the tractor hitch must be made before
operating sweeper.
&!
, */3+49/54 /- /9 2+99 :.'4
+>:8+3+ )';:/54 3;9: (+ ;9+* =.+4
:8'):58 '4* 9=++6+8 ;4/: )8+9:9 :569 5,
9:++6 ./229
Attach drive shaft quick disconnect to P.T.O. shaft
of prime mover.
!## A shield should be provided on tractor to
cover drive shaft universal joint. Do not operate drive
shaft without this shield in place.
/-;8+
8/<+ 9.',: 7;/)1 )5;62+8
&!
#./9 9=++6+8 /9 *+9/-4+* ,58 ' !
# 9.',: 542? 5 45: 56+8':+ =/:.
# :8'):58
!% "& ! ! !
%!
&!
2='?9 +36:? 9=++6+8 .566+8 (+,58+
*/9)544+):/4- .566+8 ,853 68/3+ 35<+8
58 9=++6+8 3'? :/6 (')1='8*9 '4* )';9+
/40;8?
Park sweeper on a level surface and block wheels.
On Model 07052 only, disconnect drive shaft quick
coupler from prime mover PTO shaft.
Insert castor wheel onto jack tube.
Raise sweeper jack handle and lower caster wheel
to ground.
Continue to raise sweeper with jack until hair pin
cotter and hitch pin can be removed from hitch.