Operator's Manual

28
1
2
Figure 49
1. Capscrew and locknut 2. Locknut
Flex Tip Rake Tine
Replacement
1. Remove tine retainer and slide damaged tine out.
3
1
2
Figure 50
1. Finger plate
2. Tine retainer
3. Tine
2. Bend new tine in half and slide into position.
3. Place tine bracket over curved end of tine and fasten
securely with capscrew and lockwasher.
Brush Half Replacement
1. Remove brush from sweeper.
2. Loosen clamps with a allen wrench and remove from
brush halves.
1
Figure 51
1. Clamp
3. Separate brush halves and discard damaged section(s).
Figure 52
4. Install new brush section(s) by pushing together and
secure both ends with brush clamps. When ends have
been secured, fasten brush with remaining clamps.