Operator's Manual

10
Setup
Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description Qty. Use
Drive shaft 1 Mount drive shaft blower and tractor
Canvas Ring 1 Mount to Versa Vac and attachment
Operator’s Manual 1 Read before operating the machine.
Parts Catalog 1
Registration card 1 Fill out and return to Toro.
Note: Cylinder lock bar is shipped on attachment lift
cylinder. Remove cylinder lock bar before operating
cylinder or damage may occur.
Ballast Requirements
Without the proper amount of ballast in the tires,
the tractor may become unstable and cause bodily
injury.
Make sure that the front of the tractor is equipped
with the proper amount of ballast; refer to the
tractor operator’s manual for ballast
requirements.
Caution
Mount Versa Vac to Tractor
1. Position Versa Vac on a flat, level surface.
2. Insert jack onto frame pin and secure with pin (Fig. 1).
3. Adjust jack height until Versa Vac frame is parallel with
the ground.
4. Back tractor up to vac.
5. Adjust vac hitch clevis to same level as tractor hitch as
follows:
Remove bolts and locknuts securing hitch clevis
(Fig. 2) to vac frame.
Raise or lower hitch clevis to position
approximately level with tractor hitch.
Secure with bolts and locknuts previously removed.
1
2
3
Figure 1
1. Jack
2. Pin
3. Frame pin
6. Connect tractor hitch to vac clevis hitch with hitch pin
and clevis.
7. Remove jack pin, rotate jack upward and reconnect to
frame pin for storage.