Operator's Manual

19
4. Position a large wrench on tensioner. Rotate tensioner
clockwise until decal is aligned with 15 on tensioner
tube.
5. Insert capscrew into aligned guide holes and secure
with nut. If holes are not exactly aligned, rotate guide to
the next higher hole until aligned.
6. Tighten capscrew securing, on back side of frame to
lock tensioner.
7. Install the drive shield to the impeller housing with the
capscrews, washers, and nuts.
Storage
1. Thoroughly clean the Vac. The impeller housing should
be free of dirt, leaves, and debris.
2. Check the tire pressure; refer to Checking the Tire
Pressure.
3. Check all fasteners for looseness; tighten as necessary.
4. Grease or oil all grease fittings and pivot points. Wipe
up any excess lubricant.
5. Place a light coat of grease on the splines of the PTO
shaft.
6. Lightly sand and use touch–up paint on painted areas
that are scratched, chipped, or rusted. Repair any dents
in the metal body.
Hydraulic Schematic
IN
OUT
A
B
A
A
B
B
DECK CYL
BOX DUMP CYL
B
A
OUT
IN
COMBINATION
DECK
COMBINATION
DECK
FINGER
DECK
FINGER
DECK
DECK
LIFT
BOX
DUMP