Service Manual

Workman GTX Gasoline
Drive Train
Page 4 − 6
Special Tools
Order special tools from your Toro Distributor.
Primary Clutch Removal Tool
This tool is required to remove the primary clutch from
the tapered drive shaft of the engine. It is placed in the
threaded hole of the stationary clutch sheave after the
clutch holding cap screw is removed.
Toro Part Number: TOR6039
Figure 4
Primary Clutch Spider Removal Tool Kit
This kit is required to remove the primary clutch spider
from the post of the stationary sheave. Kit includes
clutch holding bar and spanner.
Toro Part Number: TOR6016
1. Holding bar 2. Spanner
1
2
Figure 5
Secondary Clutch Press Tool
The secondary clutch press tool is used to compress the
compression spring in the secondary clutch to allow re-
moval of the retaining ring and separation of the clutch
sheaves.
Toro Part Number: TOR6027
Figure 6