Operator's Manual

g002136
Figure65
1.Brake-uidreservoir
2.Minimumline
6.Iftheuidlevelislow,performthefollowing:
A.Cleantheareaaroundthereservoircap
andremovethecap(Figure64).
B.AddDOT3brakeuidtothereservoiruntil
theuidlevelisabovetheMinimumline
(Figure65).
Note:Donotoverllthereservoirwith
brakeuid.
C.Installthereservoircap(Figure64).
7.Closethehoodofthemachine.
InspectingtheBrakes
ServiceInterval:Every100hours
Brakesareacriticalsafetycomponentofthemachine.
Aswithallsafetycomponents,theyshouldbeclosely
inspectedatregularintervalstoensureoptimum
performanceandsafety.
•Inspectthebrakeshoesandpadsforwearor
damage.Ifthelining(brakepad)thicknessisless
than1.6mm(1/16inch),thebrakeshoesshould
bereplaced.
•Inspectthebackingplateandothercomponents
forsignsofexcessivewearordeformation.Ifany
deformationisfound,theappropriatecomponents
mustbereplaced.
•Checkthebrake-uidlevel;refertoCheckingthe
Brake-FluidLevel(page51).
ChangingtheBrakeFluid
ServiceInterval:Every1,000hours
RefertoyourauthorizedAuthorizedServiceDealer.
BeltMaintenance
ServicingtheDriveBelt
CheckingtheDriveBelt
ServiceInterval:Aftertherst8hours
Every200hours
1.Parkthemachineonalevelsurface.
2.Engagetheparkingbrake.
3.Shutofftheengineandremovethekey.
4.Raisethecargobedandsecureitwiththeprop
rod;refertoRaisingtheCargoBedtotheDump
Position(page20).
5.ShiftthetransmissionintoNEUTRAL.
6.Rotateandinspectthebelt(Figure66)forsigns
ofexcessivewearordamage.
Note:Replacethebeltifitisexcessivelyworn
ordamaged;refertoReplacingtheDriveBelt
(page53).
g034106
Figure66
1.Generator-pivotnut
5.Drivebelt
2.Generator-pivotbracket
6.Primaryclutch
3.Startergenerator7.Starter-generatorbelt
4.Secondaryclutch
7.Lowerthecargobed.
52