Service Manual

Workman GTX Gasoline
Drive Train
Page 4 − 16
Transaxle Shift Cable
1. Swing arm
2. Engine
3. Spanner bar
4. Transaxle assembly
5. Shift arm
6. Flange head screw
7. Flange nut
8. Ball joint
9. Lock nut
10. Shift cable
11. Shift cable jam nut
Figure 14
v
2
3
6
8
9
10
1
5
7
4
FRONT
RIGHT
90 to 110 in−lb
(10.2 to 12.4 N−m)
11
Removal
1. Park machine on a level surface, stop engine, set
parking brake and remove key from the key switch.
2. Raise and support cargo bed to access the end of
shift cable at the transaxle.
3. Remove dash and position it toward the front of the
vehicle to access the end of the shift cable at the shift
lever (see Dash in the Service and Repairs section of
Chapter 6 − Chassis). It is not necessary to remove
choke cable from dash.
4. Disconnect shift cable from transaxle (Fig. 14):
A. Loosen jam nuts that secure shift cable to span-
ner bar (item 3). Separate cable from spanner bar.
B. Remove ball joint (item 8) from shift arm on
transaxle. Then, remove ball joint from end of shift
cable.
C. Carefully separate shift cable from clip on swing
arm.