Operator's Manual

11
Description UseQty.
Windrow Blade Mounting Assembly
Capscrew, 7/16 x 3–1/4 in.
Flatwasher
Spacer
Locknut
Windrow Blade
Flatwasher
Spacer
Locknut
Chain
Capscrew, 3/8 x 1–1/4 in.
Locknut
Snap Link
1
1
3
1
1
1
2
1
1
1
1
1
1
Mount windrow blade assembly
CE Certificate
Operators Manual
Parts Catalog
1
1
1
Read before operating the sweeper
Set Up
Special Instructions for
Workman and other utility tow
vehicles (tractors):
• The Toro Pro Sweep can be towed by most utility
tractors equipped with hydraulics producing 7 to 8
GPM @ 2000 p.s.i. and flotation tires for operation over
golf greens. The tractor must have adequate brakes and
drawbar hitch capacity to handle a 3500 lb. (1587 kg.)
trailer. Refer to Tow Vehicle Operator’s Manual for
towing instruction and precautions.
• The Workman vehicle must be equipped with the Heavy
Duty Drawbar (Model 44212 or 44213) and the
High–Flow Hydraulics Kit (Model 07228) (The 4WD
model is the best for hilly or bermed approaches to
greens).
Important Do Not attempt pulling the sweeper when
loaded with material, with the standard Workman hitch. It
is only rated to 1500 lbs. and may bend or damage the cross
tube axle support or rear spring shackles. Always use the
H.D. Drawbar Kit Model 44212 or H.D. Frame Drawbar
Model 44213.
Important Do Not attempt towing a loaded sweeper
with a light utility vehicle or run–about. They do not
normally have adequate brakes, suspension, or frame
strength to handle the weight of the sweeper.
• Trailer Brakes are highly recommended when using the
sweeper in hilly terrain. When fully loaded the sweeper
may weigh as much as 3500 lbs.(GVW). This weight is
well over the recommended towing and braking limit of
most utility vehicles. A special trailer brake kit is
available for direct installation with the Workman
vehicle. This kit could be adapted to other vehicles with
a 12 volt brake light source.