Operator's Manual

12
Install the Hitch Tongue
1. Insert the rear end of hitch tongue between the
mounting plates on the sweeper while aligning the
mounting holes (Fig. 2).
Note: The hose guides are to be positioned on top of hitch
tongue.
2. Secure the hitch tongue to the mounting plates with a
hitch pin (Fig. 2).
3. Secure the hitch pin in the mounting plates with a
3/8–16 x 1–1/4” capscrew and a 3/8–16 locknut
(Fig. 2).
1
2
3
Figure 2
1. Hitch tongue
2. Sweeper mounting plates
3. Hitch pin
Install the Actuator arm
1. Mount the rear actuator tab to the sweeper frame with
(2) 1/2–13 x 2–3/4” lg. capscrews, (4) .531 x .063 flat
washers and a 1/2–13 locknut. Position components as
shown in figure 3.
2
1
Figure 3
1. Sweeper frame 2. Rear actuator tab
2. Insert the welded tab end of the actuator arm between
the welded pins in the front actuator tab (Fig. 4).
1
4
2
5
3
Figure 4
1. Actuator arm
2. Welded tab end of
actuator arm
3. Front actuator arm
4. Hitch pin
5. Rear actuator arm
3. Secure the actuator arm to the front actuator tab with a
hitch pin (Fig. 4).
4. Insert the rear end of the actuator arm into the rear
actuator tab while aligning the mounting holes (Fig. 4).
5. Secure the actuator arm to the actuator tab with a
1/2–13 x 2–3/4” lg. capscrew, (2) .531 x .063 flat
washers and a 1/2–13 locknut. Position components as
shown in figure 4.