Operator's Manual

13
Install the Power Wire Harness
1. Route the ring terminal end of the power wire harness
to the tow vehicle battery (Fig. 5 & 7).
1
2
3
3
Figure 5
1. Power wire harness
2. J–clamp (2)
3. Wire ties
Note: Keep the harness away from any hot or moving
parts.
2. Connect the power wire harness ring terminals to the
tow vehicle battery (Fig. 7).
3. Secure the harness to the tow vehicle with wire ties at
locations shown in figure 5.
4. Install (2) J–Clips to the top of the transmission with a 8
mm x 2 screw (Fig. 5).
5. Route the harness thru the left J–Clip as shown in
figure 5.
6. Route the harness to the rear of the machine as shown in
figure 6.
1
Figure 6
1. Power wire harness
Note: Install the loop back connectors to the terminals
when not in use.
5
4
3
6
1
2
Figure 7
1. Connector to sweeper
harness
2. Loopback connector
3. Connect to negative battery
terminal
4. Connect to positive battery
terminal
5. Use for optional brake
control kit
6. Loop back connector