Operator's Manual

14
Mount the Sweeper To the Tow
Vehicle
To assure proper debris pickup, make sure sweeper frame is
parallel with the ground.
1. Position sweeper on a flat, level surface.
2. Back tow vehicle up to sweeper.
3. Adjust tow vehicle hitch to same level as sweeper hitch.
The sweeper hitch tongue is to be parallel to the ground.
4. Connect sweeper hitch tongue to tow vehicle hitch with
the hitch pin and hair pin cotter (Fig. 8).
1
2
Figure 8
1. Hitch pin 2. Hair pin cotter
Mount the Controller Box to the
Workman Vehicle
1. Mount the receiver assembly to the Workman vehicle
dash with (4) 5/16–18 x 1 in. capscrews and nuts.
Position the components as shown in figure 9.
2. Mount the controller box to the mounting assembly
with (4) screws (Fig. 9).
3. Insert the mounting assembly tube into the receiver and
secure with a clevis pin and cotter pin (Fig. 9).
4. Thread the knob into the receiver to tighten the tube
(Fig. 9).
1
2
3
4
Figure 9
1. Receiver assembly
2. Mounting assembly
3. Knob
4. Controller box
Mount the Controller Box to the
Sweeper
1. Mount the receiver assembly to the sweeper frame
bracket with (2) 3/8–16 x 1/2 in. capscrews, (4) washers
and (2) nuts. Position the components as shown in
figure 10.
2. Insert the mounting assembly tube into the receiver and
secure with a clevis pin and cotter pin (Fig. 10).
3. Thread the knob into the receiver to tighten the tube
(Fig. 10).