Operator's Manual

15
1
2
Figure 10
1. Receiver assembly 2. Knob
Route and Secure the
Hydraulic Hoses and the Wire
Harness
1. Route the hydraulic hoses and wire harness thru the
hose guides to the front of the hitch tongue (Fig. 11).
1
2
Figure 11
1. Hydraulic hoses and wire
harness
2. Hose guide
2. Secure the hydraulic hoses and wire harness as shown
in figure 12 & 13.
1
Front View
1
1
1
Figure 12
1. Cable tie (6)
1
Rear View
Figure 13
1. Cable tie (2)
Install the Controller Box
Harness
1. Remove the front and rear screws securing the right side
of the dash plate to the center console on the Workman
vehicle (Fig. 14).
2
2
1
Figure 14
1. Dash panel 2. Mounting screws