Operator's Manual

19
Mount the Windrow Blades
1. Secure the blade mounting assembly to the left end of
the sweeper frame with a 7/16 x 3–14” lg. capscrew, (3)
flatwashers, a spacer and a locknut. Position
components as shown in figure 27.
2. Secure the windrow blade to the mounting assembly
with a 7/16 x 3–14” lg. capscrew, (2) flatwashers, a
spacer and a locknut. Assembly the components as
shown in figure 27. The longer end of the blade is to be
positioned away from the sweeper.
3. Secure the chain to the blade mounting assembly with a
3/8 x 1–1/4” lg. capscrew and nut (Fig. 27).
4. Secure the other end of the chain to the slot in the frame
with the snap link (Fig. 27).There should be some slack
in the chain when connected.
5. Grease the fitting on the blade mounting assembly and
on the windrow blade hub with No. 2 Lithium Based
grease.
Note: When the windrow is not required, unhook the chain
from the snap link, pivot the windrow assembly upward
and hook the chain at the raised level.
1
2
3
5
6
3
4
Figure 27
1. Left end of sweeper frame
2. Blade mounting assembly
3. Spacer (2)
4. Windrow blade
5. Chain 6. Snap link