Operator's Manual

20
Before Operating
Adjust the Brush Height
The sweeper should be adjusted so the brush tips slightly touch the surface but do not penetrate the turf. If the brush tips do
penetrate the turf, improper debris pickup could result.
Refer to the charts below for recommended sweeper settings.
Condition
Roller/Brush Adjustment Front Flap Adjustment Notes
Greens/Tee Boxes 2 to 4 notches from bottom 1/4” to 1/2” from ground Brush should be slightly en-
gaged in the turf
Fairways 3 to 5 notches from bottom 1/2” to 1” from ground Brush should be engaged
into the top 1/3 of the grass
height
Sports fields 5 to 7 notches from bottom 1” to 3” from ground Brush should be engaged
into the top 1/3 of the grass
height
Leaves 5 to 9 notches from bottom Remove front panel Brush should be engaged
into the top 1/3 of the grass
height
Brush
Direction
1/4”–1/2”
“A” “B” “C”
Figure 28
1. Position the sweeper on a level surface.
2. Raise the hopper and install the hopper safety support.
Refer to Using the Hopper Safety Support.
3. Loosen the locknut on height adjustment key (Fig. 29)
so it can be pulled out approximately 1/2 inch.