Operator's Manual

Lubrication

Lubricate the Fittings and the

Bearings

The sweeper has (11) grease fittings that must be lubricated

regularly with No, 2 General Purpose Lithium Base Grease.

If the machine is operated under normal conditions,

lubricate all bearings and bushings after every 50 hours of

operation or immediately after every washing. Bearings and

bushings must be lubricated daily when operating

conditions are extremely dusty and dirty. Dusty and dirty

operating conditions could cause dirt to get into the

bearings and bushings, resulting in accelerated wear.

1. Lubricate the following grease fittings:

• Hopper pivot (upper) (2) (Fig. 41).

• Brush pivot (2) (Fig. 42).

• Lift cylinder (2) (Fig. 43).

• Hopper pivot (lower) (2) (Fig. 44).

• Hitch tongue pivot (1) (Fig. 45).

• Windrow blade mount (Fig. 46).

• Windrow blade hub (Fig. 46).

2. Wipe grease fittings clean so foreign matter cannot be

forced into the bearing or bushing.

3. Pump grease into the bearing or bushing.

4. Wipe up excess grease.

Figure 41

Figure 42

Figure 43

Figure 44