Installation Instructions

2
4. Loosely secure hose holder to panels with (10) self
drilling screws.
5. Position wide hose holder onto side panel rib located
above axle (third rib from the front). Hose holder to be
at the same height as narrow (front) hose holder
(Fig. 2).
6. Loosely secure hose holder to rib with (10) self
drilling screws.
7. While aligning mounting holes, position long hose
cradle onto top hose hooks of hose holders (Fig. 2).
Long end of cradle to be positioned to rear.
8. Secure hose cradle to hose hooks with (2) screws, (4)
flat washers and (4) lock nuts (Fig. 2).
9. While aligning mounting holes, position short hose
cradle onto bottom hose hooks of hose holders (Fig. 2).
10. Secure hose cradle to hose hooks with (2) screws, (4)
flat washers and (4) lock nuts (Fig. 2).
11. Insert a cap plug into end of each hose hook tube
(Fig. 2).
12. Mount an eye bolt to each rear hose hook with a
washer and lock nut (Fig. 2).
13. Remove (2) capscrews and nuts securing right end of
front brace to inside of front panel (Fig. 3).
1
Figure 3
1. Remove these capscrews
& nuts
14. Mount hanger to front panel and brace with the (2)
capscrews and nuts removed. Position hanger as shown
in figure 4.
1
Figure 4
1. Hanger
15. Slide a handle cover onto each handle of hose adapter
(Fig. 5).
1
2
2
3
4
Figure 5
1. Hose adapter
2. Handle cover
3. Vac hose
4. Hose clamp
16. Mount end of hose to hose adapter with a hose clamp
(Fig. 5).