Operator's Manual

10
2. On back side of frame, loosen capscrew securing belt
tensioner to frame (Fig. 9).
1
2
3
4
Figure 9
1. Tensioner guide
2. Capscrew & nut
3. Capscrew (back of frame)
4. Tensioner
3. Remove capscrew and nut securing tensioner guide to
drive mount (Fig. 9). Belt tension will be released when
capscrew is removed.
4. Position a large wrench on tensioner. Rotate tensioner
clockwise until decal is aligned with 15 on tensioner
tube.
5. Insert capscrew into aligned guide holes and secure
with nut. If holes are not exactly aligned, rotate guide to
the next higher hole until aligned.
6. Tighten capscrew, on back side of frame to lock
tensioner.
7. Install the motor shield with the fasteners previously
removed.
Replacing Finger Belts
1. Loosen nuts and washers securing finger pinchers to
rotor (Fig. 10).
2. Remove old belt fingers.
3. Install new belt fingers. Belt fingers to extend from
finger pinchers approximately 4 inches.
4. Tighten nuts securing assembly.
1
3
2
Figure 10
1. Finger pincher
2. Rotor
3. Belt finger