Operator's Manual

Setup

Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be

completed.

Description Qty. Use

Operator’s Manual 1 Read before operating the machine.

Parts Catalog 1

Registration card 1 Fill out and return to Toro.

Mount Finger Deck

1. Roll the deck under the Versa Vac. Make sure hydraulic

motor is on the left side.

2. Slide the tow arms onto the frame pins. Secure each tow

arm to frame pin with a washer and hair pin cotter

(Fig. 1).

Figure 1

1. Tow arm

3. Connect each lift chain to a deck bracket with a clevis

pin and hair pin cotter (Fig. 2).

Figure 2

1. Lift chain

4. Install canvas ring around the lip on the Versa Vac and

deck openings (Fig. 3).

Figure 3

1. Canvas ring

5. Connect hydraulic motor hose quick couplers to the

Versa Vac couplers as shown in figures 4.

Note: Verify rotation of fingers. Fingers should rotate

clockwise (as viewed from motor end of deck).

Figure 4

1. Motor hose –front

2. Motor hose –center

3. Motor hose –rear

Note: If deck is not level when it is raised off the ground,

reposition lift chain in another mounting hole in bracket.