Installation Instructions

ManualsBrandsToro ManualsAttachmentsBrake Kit, Turf Sweeper

Printed in the USA

W 2005 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Brake Kit

Pro Sweep 5200

Model No. 07086

Form No. 3352–711

Installation Instructions

1. Park the sweeper on a level surface.

2. Raise the left wheel off of the floor and place support

blocks under the sweeper frame.

3. Remove the lug nuts securing the left wheel and tire

assembly to the wheel hub (Fig. 1). Remove the tire

and wheel assembly.

Figure 1

1. Wheel & tire assembly

2. Lug nut

3. Wheel hub

4. Remove the grease cap, cotter pin, castle nut and

washer securing the wheel hub to the axle shaft

(Fig. 2). Remove the wheel hub from the axle shaft.

Make sure all the wheel hub components are off the

shaft and that the shaft is free of any debris.

Figure 2

1. Grease cap

2. Cotter pin

3. Castle nut

4. Washer

5. Wheel hub

6. Axle

5. Insert the left brake assembly onto the axle shaft and

secure it to the wheel hub with (4) 7/16” nuts. Position

the brake assembly onto the axle as shown in figure 3.

Figure 3

1. Left brake assembly 2. Nut, 7/16” 3. Brake drum

Summary of content (4 pages)

PAGE 1
Form No. 3352–711 Brake Kit Pro Sweep 5200 Model No. 07086 Installation Instructions 1. Park the sweeper on a level surface. 4. Remove the grease cap, cotter pin, castle nut and washer securing the wheel hub to the axle shaft (Fig. 2). Remove the wheel hub from the axle shaft. Make sure all the wheel hub components are off the shaft and that the shaft is free of any debris. 2. Raise the left wheel off of the floor and place support blocks under the sweeper frame. 3.
PAGE 2
6. Mount the brake drum to the axle shaft with a washer, castle nut, cotter pin and grease cap, positioning the components as shown in figures 2 & 3. 9. Connect the brake harness to the left and right brake connectors (Fig. 4). The end of the harness with the two connectors is to be positioned at the right end of the axle. 7. Mount the new wheel and tire assembly to the brake drum with the (5) lug nuts included (Fig. 3). 10. Secure the brake harness to the axle in several places with wire ties. 8.
PAGE 3
13. Mount the brake controller to the dash panel, below the steering wheel, using the two #10–24 x 2 inch screws provided (Fig. 6 & 7). C. Attach the 2-terminal connector (one green, one black) to the mating open connector (one white/black, one brown) from the Workman vehicle’s wire harness (Fig. 8). This connector is located under the dash. 3 1 4 Figure 6 2 1. Brake controller 1 6 5 7 Figure 8 1. 2. 3. 4.
PAGE 4
Using the Brakes The electric trailer brakes are designed to be actuated automatically whenever the brake pedal of the Workman Vehicle is depressed. The trailer brakes alone may be actuated by depressing the red manual override bar on top of the brake controller. Always assure the trailer brakes are connected and functioning properly before using the equipment. 1.