Service Manual

Workman GTX ElectricPage 5 -- 12Chassis
Front Wheels and Hubs
1. Front wheel assembly
2. Lug nut (4 per wheel)
3. Front brake caliper (LH shown)
4. Socket head screw (2 per caliper)
5. Front brake line
6. Banjo bolt and washers
7. Dust cap
8. Retainer
9. Cotter pin
10. Jam nut
11. Tab washer
12. Bearing (2 per hub)
13. Front wheel hub
14. Wheel stud (4 per hub)
15. Brake rotor
16. Socket head screw (4 per rotor)
17. Oil seal
18. Spindle (LH shown)
Figure 10
FRONT
RIGHT
3
6
8
9
11
1
5
7
2
2
4
10
12
13
14
14
1
15
12
16
17
18
18
35 to 40 ft
−
lb
(48 to 54 N
−
m)
9to11ft
−
lb
(13to14N
−
m)
75 to 95 ft
−
lb
(102 to 128 N
−
m)
See text for
tightening
procedure
Lifted suspension
models
Medium Strength
Thread Locker
Removal (Fig. 10)
1. Park vehicle on a level surface, turn key switch OFF,
apply parking brake and remove key from the key
switch.
WARNING
Before jacking up the vehicle, review and follow
Jacking Instructions in Chapter 1 -- Safety.
2. Chock wheels not being removed. Use a jack to raise
front wheel that is to be removed off the ground. Support
vehicle with appropriate jack stands beneath the frame.
3. Remove four (4) lug nuts and then remove front
wheel assembly from the wheel hub.
4. Remove two (2) socket head screws that secure
front brake caliper to the mounts on the spindle. Slide
caliper assembly with attached brake line from brake ro-
tor and support caliper away from the front wheel hub.