Service Manual

Workman GTX Electric

Page 3A -- 2

Electrical System

General Information

The Workman GTX Electric uses a 48 VDC electrical

system that is an isolated circuit. The vehicle frame is

not used for any ground connections.

The vehicle controller monitors operator and vehicle in-

puts to determine voltage to the traction motor. If a prob-

lem exists that will prevent normal vehicle operation, an

LED on the controller and the status indicator light on the

dash panel will flash a fault code to assist in identifying

the problem.

After performing any repair on electrical components on

the vehicle, make sure that wiring is routed and secured

so as to prevent abrasion or contact with moving vehicle

parts.

Operator’s Manual

The Operator’s Manual provides information regarding

the operation, general maintenance and maintenance

intervals for your Workman vehicle. Refer to the Opera-

tor’s Manual for additional information when servicing

the machine.

Electrical Drawings

The electrical schematic and other electrical drawings

for the Workman GTX Electric are located in Chapter 6

-- Electrical Drawings.

Rear Frame Panel Cover

A panel cover is secured to the top of the rear frame be-

hind the seats to prevent debris entry to the front of the

swing arm area. The cover can easily be removed by re-

leasing the latches and lifting the cover from the rear

frame.

1. Rear frame

2. Panel cover

3. Latch (2 used)

Figure 1

FRONT