Service Manual

Workman GTX Electric Page 3A -- 15 Electrical System

Light Switch

The light switch allows the headlights to be turned ON

and OFF. This rocker switch is located on the dash panel

(Fig. 17).

NOTE: The Workman GTX Electric headlight circuit is

a12VDCcircuit.

Testing

1. Parkvehicleonalevelsurface,turnkeyswitchto

OFF, engage the parking brake and remove key from

the key switch.

2. Raise hood to allow access to wire harness connec-

tions for switches mounted in dash.

3. Disconnect wire harness connector from the light

switch.

4. With the use of a multimeter (ohms setting), the

switch functions may be tested to determine whether

continuity exists between the various terminals for each

light switch position. The light switch terminals are

markedasshowninFigure18.Thecircuitryofthis

switch is shown in the chart below. Verify continuity be-

tweenswitchterminals.

SWITCH

POSITION

NORMAL

CIRCUITS

OTHER

CIRCUITS

ON 2+3 5+6

OFF 1+2 4+5

5. Replace light switch if testing determines that the

switch is faulty.

6. If light switch tests correctly and circuit problem still

exists, check fuse, headlights and wire harness for pos-

sible problems (see electrical schematic and wire har-

ness drawing in Chapter 6 -- Electrical Drawings).

7. After light switch testing is complete, connect wire

harness connector to the light switch. Lower and secure

front hood.

1. Dash panel 2. Light switch

Figure 17

Figure 18

Electrical

System