Service Manual

Workman GTX Electric Page 3A -- 31 Electrical System

Reverse Audio Alarm (If Equipped)

The reverse alarm sounds when the direction switch

(forward/reverse) is placed in the reverse position. The

alarm is located under the seat assembly attached to the

rear frame panel near the fuse block (Fig. 39).

Testing

IMPORTANT: Make sure to observe polarity on the

alarm terminals when testing. Damage to the alarm

may result from an improper connection.

IMPORTANT: The audio alarm is a 12 volt DC c om-

ponent. Do not test the alarm using jumper wires

from the vehicle battery pack (48 VDC).

1. Parkvehicleonalevelsurface,turnkeyswitchto

OFF, engage the parking brake and remove key from

the key switch.

2. Remove seat assembly from vehicle to access re-

verse alarm. Locate alarm on rear frame panel.

3. Disconnect wire harness connectors from alarm

(Fig. 39).

4. Using jumper wires, correctly connect 12VDC

source to the alarm terminals noting polarity shown in

Figure 40.

5. Alarm should sound as long as voltage is applied to

alarm terminals. Remove voltage source from the

alarm.

6. Replace alarm if testing determines that it is faulty.

7. Connect wire harness connectors to alarm. Install

seat assembly on vehicle.

1. Fuse block 2. Reverse audio alarm

Figure 39

FRONT

1. Alarm (top view)

2. Alarm (bottom view)

3. Positive (+) terminal

4. Negative (--) terminal

Figure 40

Electrical

System