Service Manual
28. To reduce potential fire hazard, keep the engine
area free of excessive grease, grass, leaves and accu-
mulation of dirt.
29. If the engine must be running to perform a mainte-
nance adjustment, keep hands, feet, clothing, and any
parts o
f the body away from the engine and any moving
parts. Keep everyone away.
30. Do not over–speed engine by changing governor
settings. Maximum engine speed is 3650 RPM. T
o as-
sure safety and accuracy, have an Authorized Toro Dis-
tributor check maximum engine speed with a
tachometer.
31. If major repairs are ever needed or assistance is re-
quired, contact an Authorized T
ORO Distributor.
Jacking Vehicle
32. To be sure of optimum performance and safety, al-
ways purchase genuine TORO replacement parts and
accessories. Replacement parts and accessories made
by other manufacturers could be dangerous. Altering
this vehicle in any manner may affect the vehicle’s op-
eration, performance, durability or its use may result in
injury or death. Such use could void the product warran-
ty of The Toro Company.
33. This vehicle should not be modified without the T
oro
Company’s authorization. Direct any inquiries to:
The Toro Company
Commercial Division
V
ehicle Engineering Dept.
300 West 82nd St.
Bloomington, Minnesota 55420–1196. USA
1
CAUTION
hoists and jacks. Always chock or block the
wheels and use jack stands or solid wood
blocks to support the machine. If the traction
When changing attachments, tires or per-
forming other service, use the correct blocks,
unit is not properly supported by blocks or
jack stands, the unit may move or fall result-
ing in personal injury.
Figure 1
1. Front jacking point
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause ve-
hicle to slip off jack.
2. Do not work under vehicle without jack stands sup-
1
1
porting it. The vehicle could slip off jack, injuring any one
Figure 2
beneath it.
1. Rear jacking points
3. The jacking point at the front of the vehicle is under
the front center frame support and at the rear it is under
the axle tube.
4. When jacking up front of vehicle, always place a 2x4
block (or similar material) between jack and
vehicle
frame.
Safety
Page 1
– 4
Rev. C
Workman 3000 Series