Service Manual

Safety
Using Bed Safety Support
Many of the procedures shown in this manual re-
quire raising and lowering the bed. The following
precautions must be taken or serious injury or
death could result.
Before servicing or making adjustments to
and remove key from ignition switch. Any
load material must be removed from bed or
other attachment before working under
raised bed. Never work under a raised bed
installed cylinder rod.
After work is completed, remove safety support,
1
2
WARNING
the machine, stop engine, set parking brake
without positioning safety support on a fully
slide it onto storage stud and lower bed.
Figure 3
1. Bed support
2. Storage stud
1. Raise bed until lift cylinders are fully extended.
2. Remove bed support from storage stud on top of back
rest support channel on W
orkman (Fig. 3).
3. Push bed support onto cylinder rod, making sure sup-
port end tabs rest on end of cylinder barrel and on cylin-
der rod end (Fig. 4).
4. To store bed support, remove bed support from cylin-
d
er and insert on stud on top of back rest support chan-
nel.
5. Always install or remove bed support from outside of
bed.
6. Do not try to lower bed with bed safety support on cyl-
inder
.
1
2
3
Figure 4
1. Bed support
2. Cylinder barrel
3. Bed
Workman 3000 Series
Page 1 – 5
Safety