Service Manual

Stub Axle
Use an extra stub axle (Toro P/N 87–8740) with washer
(Toro P/N 87–3060) and flange lock nut (Toro P/N
32128–53) as a tool to install stub axle. Attach this tool
to the wheel studs on the stub axle. Secure tool with
wheel nuts. Use a 1–1/8 six point socket, torque
wrench, and modified 1–1/8 combination wrench to
tighten stub axle flange nut to a torque of 300 – 340 Nm
(220 – 250 ft–lb).
Figure 6
Clutch Alignment Tool
Use this tool to align clutch friction disk to engine fly-
wheel before tightening clutch cover capscrews.
Mitsubishi Motors Part No. MD999572
Figure 7
NOTE: Main shaft (Toro P/N 92–0663) from transaxle
can also be used as an alignment tool.
Figure 8
Workman 3000/4000 Series Page 6
– 5 Drive Train
Drive Train