Service Manual

Drive Train
Rev. A
Workman 3000/4000 Series Page 6 – 13 Drive Train
Stub Axle and Drive Shaft Service
2
1
7
8
10
6
3
11
9
5
4
(45 – 55 ft–lb)
60 – 75 Nm
(220 – 250 ft–lb)
300 – 340 Nm
Loctite 271
(35 – 42 ft–lb)
47 – 57 Nm
Drive Shaft with Half Yoke
Half yoke
Figure 19
1. Wheel nut 5. Washer 9. Locknut
2. Wheel and tire 6. Stub axle 10. Seal
3. Brake drum 7. Bearing with thin spacer 11. Bearing
4. Flange nut 8. Spacer
NOTE: Later production machines have a half yoke on
the stub axle. See inset in Figure 19.
Stub Axle and Driveshaft Removal
1. Loosen wheel nuts (Item 1).
2. Jack up rear of machine and support with jack stands.
3. Remove wheel (Item 2).
4. Remove brake drum (Item 3).
5. On early production machines, not equipped with a
half–yoke, insert modified 1–1/8 box end wrench on
stub axle flange nut (Item 4). NOTE: On machines
equipped with a half yoke type driveshaft, remove the
straps securing the bearing cross to the half yoke, then
disconnect the drive shaft. You can then use a standard
1–1/8 box end wrench.
Figure 20