Service Manual

31. Disassemble differential fork shaft assembly:
A. Remove O–ring (Item 1) from fork shaft.
B. Remove snap ring (Item 2), washer (Item 3) and
spring (Item 4).
C. Remove fork (Item 5).
D. Remove lock pin (Item 6) if necessary.
Figure 68
32. Disassemble axle shaft assemblies:
A. Remove O–ring (Item 1) from dif
ferential carrier.
B. Remove snap ring (Item 2).
C. Remove L.H. axle shaft assembly (Item 3).
D. Remove snap ring (Item 4) and washer (Item 5).
E. Use a bearing puller to remove bearing (Item 6)
from axle shaft.
F. Remove oil seal (Item 7) from differential carrier
(Item 8).
G. Remove R.H. axle shaft assembly (Item 1) from
seal cover
.
H. Remove snap ring (Item 2) and washer (Item 3)
from axle shaft.
I. Use a bearing puller to remove bearing (Item 4).
J. Remove oil seal (Item 5) from seal cover.
Figure 69
Drive Train Page 6
– 32 Workmand 3000 /4000 Series