Service Manual

10. Assemble reduction shaft:
A. Install washer(s) (Item 17), 2 needle bearings
1
3
5
15 14
13 10
7
(Item 16) and gear (Item 15) onto reduction shaft
(Item 18). Apply moly disulfide grease to washer
a
nd needle bearings before installing. Oil groove on
washer must face the gear.
B. Install synchro ring (Item 14) onto gear (Item 15).
Apply
Dexron II transmission oil on cone face of
gear before installing synchro ring.
C. Insert key (Item 13) onto reduction shaft.
18
2 4 17
16
12
11
8
6
D. Install synchro hub sub–
assembly (Item 12).
9
E. Install snap ring (Item 11).
F. Install spacer (Item 10) onto gear (Item 8).
Figure 95
G. Insert needle bearings (Item 9) into gear (Item 8).
H. Install washer (Item 7). Oil groove on washer
must face the gear
.
I. Use a press to install bearing (Item 6).
1
2
3
4
5
18
13
17
16
15
14
12
11
8
9
7
6
Figure 96
Drive Train Page 6
– 42 Workmand 3000 /4000 Series