Service Manual

5. Remove PTO drive shaft:
C. Shift PTO to ”ON” position.
D. Remove 2 snap rings (Item 1, 2) from PT
O case.
E. Slide drive shaft assembly (Item 3) toward PTO
shaft side.
F. Remove bearing (Item 4).
G. Slide drive shaft toward other side.
H. Remove bearing (Item 5).
I. Remove washer (Item 6) and gear (Item 7),
sliding
Figure 137
drive shaft toward PTO shaft side.
J. Release shift arm (Item 8) from block (Item 9).
K. Remove drive shaft assembly.
3
6
7
8
Figure 138
6. Disassemble PTO drive shaft:
A. Remove shifter (Item 1).
B. Remove 2 steel balls (Item 2) and spring (Item 3).
2
1
3
Figure 139
Drive Train
Workman 3000/4000 Series
Page 6 – 57
Drive Train