Service Manual

Power Take–Off (PTO) Reassembly
NOTE: Item numbers in figures are shown in reverse or-
der of assembly; for example, when
reassembling,
install Item 1 last.
1. Clean gasket material from mating surfaces of case
and cover
.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
2. Make sure all parts should be free of dirt and dust.
3. Assemble shift arm:
2
1
3
Figure 148
A. Install 2 new O–rings (Item 1) onto shift arm. Ap-
ply moly disulfide grease to O
–rings before instal-
ling.
B. Apply moly disulfide grease to arm pin and shaft.
C. Install shift arm into PTO case.
D. Install arm onto shift arm
E. Drive lock pins into arm and shift arm. Pay atten-
tion to direction of slit in lock pins.
Figure 149
5
Figure 150
Drive Train
Page 6
– 60
Workman 3000/4000 Series