Service Manual
Power Take–Off (PTO) Inspection
1. Thoroughly clean and dry all parts.
2. Use emery cloth to remove nicks and burrs from all
parts.
3. Measure clearance between shifter groove and shift-
er
block. Replace shifter block if clearance exceeds 1.0
mm (.039 in.).
Figure 144
4. Measure I.D. of bushing (Item 1). Replace bushing if
I.D. exceeds 17.10 mm (.673 in.).
1
Figure 145
5. Measure O.D. of bushing area on shaft. Replace shaft
if O.D. is less than 16.95 mm (.667 in.). Inspect surface
of bushing area for scoring or damage.
Figure 146
6. Inspect surface of oil seal area for wear or damage.
Figure 147
Workman 3000/4000 Series
Page 6
– 59
Drive Train
Drive Train