Service Manual
Rev. D
Workman 3000 SeriesPage 7 – 18Steering, Brakes and Suspension
Steering Wheel Installation
1. Slide foam seal, steering wheel and washer onto
steering shaft.
2. Secure steering wheel to shaft with jam nut and tight-
en to a torque of 10 – 15 ft–lb (13 – 20 Nm).
3. Install cap to steering wheel.
2
5
4
3
1
Figure 17
1. Foam seal 3. Washer 5. Cap
2. Steering wheel 4. Jam nut
Steering Linkage Service
180 – 210 ft–lb
(244 – 285 Nm)
Wash nylon bearings with water
DO NOT lubricate
Pitman Arm (4WD)
Pitman Arm (2WD)
Figure 18
Note: Do not attempt to disassemble U–joints. U–joint
parts are not replaceable.
Note: The pitman arm has a splined and tapered joint.
Use a puller when removing.
1. Disassemble and reassemble as shown in illustra-
tion.