Installation Instructions

ManualsBrandsToro ManualsAttachmentsRear Lift Kit, Workman e2050 Utility Vehicle

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Rear Lift Kit

Workman



e2050 Utility Vehicle

Model No. 07261

Form No. 3350-432

Installation Instructions

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to identify parts for assembly.

Description Qty. Use

Rear lift frame assembly

Actuator

Clevis pin, short

Clevis pin, long

Hair pin

Hitch plate

Flange bolt

Rear lift harness

Installing the box lift

Solenoid

Solenoid mounting plate

Screw, #10 x 3/4 inch

Nut, #10

U-bolt

Locknut, 3/8 inch

Accessory harness

Cable tie

Installing the wiring harness

Installation instructions 1 Read before installing kit

Parts catalog 1 Use to order new parts

Summary of content (8 pages)

PAGE 1
Form No. 3350-432 Rear Lift Kit Workman e2050 Utility Vehicle Model No. 07261 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Note: Use the chart below to identify parts for assembly. Description Qty.
PAGE 2
PAGE 3
Installing the Rear Lift Kit Caution 1. Position the machine on a level surface. Set the parking brake, turn the ignition off, and remove the key. Damage to the actuator may occur if the hitch plate with a trailer ball is attached during operation of the rear lift. Caution • Only use a hitch plate with a trailer ball when the actuator is removed. If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure you or other bystanders. 8.
PAGE 4
PAGE 5
3. Locate the optional 48v output connector as labeled on the main harness and remove the cap. Connect the accessory harness to the 48v output connector as shown in Figure 5. 2 1 10 6 1 9 7 8 4 2 3 4 6 5 m–7653 7 Figure 3 1. 2. 3. 4. Solenoid plate Solenoid, existing Solenoid, new Bolt, #10 x 3/4 inch 5. 6. 7. 8. 5 Nut, #10 Accessory harness Large posts Small posts 3 m–7658 Figure 5 2. Attach the accessory harness to the solenoid. Connect a large ring to each large post.
PAGE 6
PAGE 7
. Remove the plug from the hole in the right side of the dash (Fig. 6). 8. Remove the plug from the middle hole in the dash (Fig. 6). 1 2 Figure 6 1. Plugged hole 2. Switch 9. Insert the switch into the hole in the dash (Fig. 6). Warning Loose or improperly secured battery connections could damage the vehicle and cables causing sparks. Sparks can cause the battery gasses to explode, resulting in personal injury. • Always ensure the battery polarity when making connections. 10.
PAGE 8