Installation Instructions
1
All Rights Reserved
Printed in the USA
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Folding Windshield Kit
Workman
1100/2100 and Twister Utility Vehicle
Model No. 07293
Model No. 07293R
Form No. 3326-470 Rev A
Installation Instructions
Note: To attach the Folding Windshield Kit, you must have
a Canopy Kit (Model No. 07297 or 07297R) installed on
your vehicle.
Assembly
1. Position the machine on a level surface. Set the parking
brake, turn the ignition off, and remove the key.
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
Caution
2. Attach the windshield tube to the front support tubes on
the canopy using 2 screws, flat washers, and capped
nuts (Fig. 1).
3. Remove the protective film from the windshield.
4. Install the snap-on clips and receiver clips as shown in
Figure 1.
5. Hold the rubber clips (Fig. 1) and attach the top of the
windshield to the canopy frame.
6. Attach the snap-on clips on the side of the windshield to
the canopy frame. Align the clips on the bottom of the
windshield with the windshield tube and press the
windshield securely into place (Fig. 1).
7. Ensure that all of the clips are secured firmly to the
frame.
2
1
3
5
4
6
Figure 1
1. Windshield tube
2. Screw and flat washer
3. Capped nut
4. Snap-on clip
5. Receiver clip
6. Rubber clip
Maintenance
Danger
Remove the folding windshield before transporting
the vehicle on a trailer.
Important To prevent degrading of the windshield,
clips, and hinge, clean the windshield with mild soap and
water only. Do not use glass cleaners and solvents such as
ammonia, alcohol, and petroleum distillates.