Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 07297R

Printed in the USA

 2001 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Canopy Kit

Workman



1100/2100 and Twister Utility Vehicle

Model No. 07297

Model No. 07297R

Form No. 3326-769 Rev B

Installation Instructions

Safety and Instruction Decals

Safety decals and instructions are easily

visible to the operator and are located near

any area of potential danger. Replace any

decal that is damaged or lost.

104-6731

Assembly

1. Position the machine on a level surface. Set the parking

brake, turn the ignition off, and remove the key.

If you leave the key in the ignition switch, someone

could accidently start the engine and seriously

injure you or other bystanders.

Remove the key from the ignition switch before

you do any maintenance.

Caution

2. If your vehicle has a Roll Over Protection System

(ROPS), proceed to step 3. If your vehicle does not

have a ROPS, proceed as follows:

A. Loosely attach the support brackets to the rear

support tube with 8 screws, 4 (5/16 x 2-3/4 in.) and

4 (5/16 x 1-3/4 in.); 16 flat washers (5/16 in.); and 8

flange nuts (5/16 in.) (Fig. 1).

B. Loosely attach the support brackets to the vehicle

with 8 screws (5/16 x 1 in.), 16 flat washers

(5/16 in.), and 8 flange nuts (5/16 in.) (Fig. 1).

3. Remove the rear bolt that holds the front fender to the

dash and front frame support on each side of the

vehicle. Do not remove the fenders from the vehicle

(Fig. 1).

Figure 1

1. Rear support tube

2. Left-hand support bracket

3. Screw, 5/16 x 2-3/4 in.,

and washer, 5/16 in.

4. Screw, 5/16 x 1-3/4 in.,

and washer, 5/16 in.

5. Flange nut and washer,

5/16 in.

6. Screw, 5/16 x 1 in,. and

washer, 5/16 in.

7. Left-hand front fender

8. Right-hand front support

9. Left-hand front support

Summary of content (2 pages)

PAGE 1
Form No. 3326-769 Rev B Canopy Kit Workman 1100/2100 and Twister Utility Vehicle Model No. 07297 Model No. 07297R Installation Instructions Safety and Instruction Decals 2. If your vehicle has a Roll Over Protection System (ROPS), proceed to step 3. If your vehicle does not have a ROPS, proceed as follows: Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. A.
PAGE 2
4. Slide the slotted bracket on the front support between the fender and vehicle. Loosely attach the front supports to the floor of the vehicle using the existing hardware on the vehicle (Fig. 1). 2 1 3 5. Secure the fenders with the bolts removed in step 3. 6. Loosely attach the canopy to the front supports using 4 long screws (5/16 x 2-3/4 in.), 8 flat washers (5/16 in.), and 4 flange nuts (5/16 in.) (Fig. 2). Note: The canopy support is already loosely attached to the canopy (Fig. 2).