Operator's Manual

18. Using dimensions shown in figure 9, locate, mark

and drill a .281" dia. hole in left rear end of bed. Repeat

procedure on right rear end of bed.

Figure 9

1. Left rear end of bed

3.18"

.562" (2)

.281" dia.

(2)

TO FRONT

19. Mount a rubber bumper and (2) washers to each

hole in rear of bed with a Keps nut (Fig. 10). Washers to

be postioned between bumper and rear of bed.

Figure 10

1. Rubber bumper

OPERATION

1. Maximum weight on folded down panels is 300 lb.

Exceeding this limit may cause damage to side panels.

2. Never carry passengers in bed.

3. Spring loaded latches can bruise or pinch. Close

latches slowly.

4. Any one panel or combination of panels may be

folded down.

5. When mounting a core harvester on bed, secure

left end of front panel and front end of left side panel

together with a 5/16-18 x 7/8" lg. carriage bolt and

flange (Toplok) locknut, as shown in figure 11. Right

corner may be secured if desired.

IMPORTANT: Keep tailgate latched when core

harvester is mounted on machine. This gives added

support to side panel with conveyor. Release tailgate

only when dumping.

Figure 11

1. Capscrew & locknut