Installation Instructions

10. Remove the bed safety support from the cylinder and place
it on the storage stud.
11. Start the engine and engage the hydraulic lift lever to lower
the bed. Release the lift lever and turn off the engine.
INSTALLING THE 2/3-SIZE FLAT BED
Same as full bed installation except for the following:
1. Mount the rear pivots plates so the lower ends angle for-
ward.
2. The rear slots are for full-bed installation and the front
slots are for 2/3-bed installation.
WARNING: The 1/3 mid-area must be covered when the 2/3
bed is used on the Workman. This can be done by installing 1/3
bed, 1/3 tool box or 1/3 cover.
FULL & 2/3 BED REMOVAL
1. Start the engine. Engage the hydraulic lift lever and lower
the bed until the cylinders are loose in the slots. Release
the lift lever and turn off the engine.
2. Remove the lynch pins from the outer ends of the cylinder
rod clevis pins.
3. Remove the clevis pins securing the cylinder rod ends to
the bed mounting plates by pushing the pins toward the
inside.
4. Remove the lynch pins and clevis pins securing the pivot
brackets to the frame channels.
5. Lift the bed off the vehicle.
CAUTION: The full bed weighs approximately 78 kg, so
do not try to install or remove it by yourself. Get two or
three other people to help.
6. Store the cylinders in the storage clips. Engage the
hydraulic lift lock lever on the vehicle to prevent accidental
extension of the lift cylinders.
5