Installation Instructions

FormNo.3360-604RevA

SolidWindshieldKit

forWorkman®MD,MDX,MDEUtilityVehicle

ModelNo.07325

InstallationInstructions

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

Note:ToattachtheSolidWindshieldKit,youmusthaveaCanopyKit(07324)installedonyourvehicle.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Windshield,solid1

Snaponclip,windshield(10inch)

Windshieldtube1

Bolt(1/4x1-1/4inch)

Flatwasher(1/4inch)

Cappednut(1/4inch)

Installthewindshieldkit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3360-604 Rev A Solid Windshield Kit for Workman® MD, MDX, MDE Utility Vehicle Model No. 07325 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Note: To attach the Solid Windshield Kit, you must have a Canopy Kit (07324) installed on your vehicle. Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
G009293 2 1 6 3 5 4 3 Figure 1 1. Windshield 2. Snap-on clip 3. Windshield tube 4. Capped nut 5. Canopy frame 6. Bolt and flat washer Maintenance 1. Position the machine on a level surface. Set the parking brake, turn the ignition off, and remove the key. Remove the solid windshield before transporting the vehicle on a trailer. If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure you or other bystanders.