Installation Instructions

Manual No. 3353-669 Rev D
Installation Instructions and Parts Manual
11-21-05
05-10435
Set up instructions
The sunshade is designed to be only used with a Workman vehicle equipped with a ROPS and all decals
must be installed and legible.
Preparation of Workman
21. Position vehicle on a clean level surface, stop engine, engage parking brake and remove key from
ignition switch.
Assembly of Frame
22. Pre-assemble the structural frame. Loosely attach, tighten all fasteners later in these instructions.
Reference drawing 4-14770, sheets 1, 2 and 3.
23. Start by assembling horizontal support tubes into the rear mount bracket. Secure components
with (4) 5/16” x 1.50” bolts, (8) 5/16” flat washers and (4) 5/16” nylock nuts. See Figure 1.
24. Secure front mount bracket to the front of horizontal support tubes and secure with (4) 5/16” x
2.00” bolts, (8) 5/16” flat washers and (4) 5/16 nylock nuts. See Figure 2.
25. Assemble front upright support tubes to the front mount bracket. Fasten with (4) 5/16” x 2.00”
bolts, (8) 5/16” flat washers and (4) 5/16 nylock nuts. See Figure 2.
26. Assemble middle support bracket to middle of frame and fasten with (2) ¼ x 1.75” long bolts, (4)
¼” flat washers and (2) ¼” nylock nuts. See Figure 5.
Figure 1
Figure 2
HORIZONTAL
TUBE
REAR
MOUNT
FRONT
MOUNT
BRACKET
HORIZONTAL
SUPPORT
Step 25
Step 23
Step 24
Page 3 of 8