Installation Instructions

Manual No. 3353-669 Rev D
Installation Instructions and Parts Manual
11-21-05
05-10435
27. Secure the back of the frame structure onto workman ROPS (Roll bar). Center and secure with
(2) 3/8” square U-bolts, (4) 3/8” flat washers and (4) 3/8-16unc nylock nuts. See Figure 3.
28. Secure front of frame to front hood by removing (2) 5/16 x 1.50” long bolts which are to be re-
installed in Step 29. Also remove the inner rubber threaded grommet from each side of hood and
discard.
29. Apply self adhesive foam pad to upright tube bracket hood side surface. Align bottom front upright
bracket and re-install the (2) 5/16 x 1.50” long bolts with (4) 5/16” flat washers, and (2) 5/16”
nylock nuts. See Figure 4. See drawing 4-14770 for proper installation of nylock nuts and flat
washers.
REAR MOUNT
3/8” SQUARE
U-BOLTS
WORKMAN’S
ROPS
HORIZONTAL
SUPPORT
Figure 4
Steps 28 & 29
Figure 3
Page 4 of 8