Installation Instructions

FormNo.3360-610RevA

Heavy-DutyBrushguardandBumperKit

forWorkmanMD/MDX/MDEUtilityVehicle

ModelNo.07338

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

BrushguardandBumperAssembly1

FlangeBolt(3/8x5inch)

Bolt(3/8x1inch)

Locknut(3/8inch)

Installthebrushguardandbumper.

InstallingtheBrushguardand

Bumper

1.Locatethetwoexposedboltsontheexistingfront

bumper.Removetheboltsandlocknutsanddiscard.

Theexistingplasticbumperstaysinplace.

G008825

Figure1

1.Frontbumperbolts

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3360-610 Rev A Heavy-Duty Brushguard and Bumper Kit for Workman MD/MDX/MDE Utility Vehicle Model No. 07338 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Brushguard and Bumper Assembly Flange Bolt (3/8 x 5 inch) Bolt (3/8 x 1 inch) Lock nut (3/8 inch) Use Qty. 1 2 4 6 Install the brushguard and bumper. Installing the Brushguard and Bumper 1. Locate the two exposed bolts on the existing front bumper.
PAGE 2
. Install the brushguard and bumper assembly to the front mounting plate above the towing tongue and below the exiting plastic bumper (Figure 2). G008826 6 1 2 3 4 5 7 Figure 2 1. Brushguard and bumper 2. Flange bolt (3/8 x 5 inch) 3. Bolt (3/8 x 1 inch) 4. Mounting plate 5. Lock nut (3/8 inch) 6. Front bumper 3. Use four bolts (3/8 x 1 inch) and four lock nuts (3/8 inch) to secure the brushguard and bumper assembly to the mounting plate (Figure 2).