Installation Instructions

PAGE 1
( MODEL NO. 07345 t 1/3 POWER PLATFORM J FORM NO. 3317725 INSTALLATION INSTRUCTIONS For Workman ® 3000 Series Note: 1/3 Power Platform is used in conjunction with the 1/3 Flatbed, Auxiliary Power Unit (KAPUT, electric clutch and hand throttle kit {optional). Refer to Workman vehicle, 1/3 Fiat bed, APU, electric clutch and hand throttle Operator's Manuals for additional operation, adjustment and satiety information. 1. Remove 1/3 flatbed from Workman Vehicle.
PAGE 2
9. Hook spring ends to idler arm and platform pin, as shown in figure 4, 10. Install desired accessory (i.e. air compressor or pressure washer) to platform. Refer o Installation instructions supplied with accessory. 11. Install optional tool box as follows: A. Position tool box on power platform aligning mounting holes with holes in platform. {Toolbox fits on either side of platform) B. From inside tool box, secure to platform with (4) x 3/4" Ig. cap screws (Fig. 5). Figure § 1. Too! box 12.