Installation Instructions

ManualsBrandsToro ManualsAttachmentsDoor Kit with Fixed Windows, Model 07339 Cab for Workman HD/HDX/HDX-D Utility Vehicle

TORO DELUXE HARD CAB DOORS

This cab is manufactured for TORO

by Jodale Perry Corporation.

These door kits are intended to

be used on the following cab :

TORO WORKMAN

Heavy-Duty Series Cab

07339

Model’s 07375 &07376

1. Safety instructions/Specifications..…………………………….2

2. Loose parts………………………………………………………3

3. Installation instructions…………….……………………………4

4. Warranty statement……………………………………………..5

Table of contents

Solid Window Door

Kit Model 07376

Sliding Window Door

Kit Model 07375

Installation Instructions

3362-444 REV A

Summary of content (6 pages)

PAGE 1
3362-444 REV A TORO DELUXE HARD CAB DOORS Model’s 07375 &07376 Installation Instructions These door kits are intended to be used on the following cab : TORO WORKMAN® Heavy-Duty Series Cab 07339 Sliding Window Door Kit Model 07375 Solid Window Door Kit Model 07376 Table of contents This cab is manufactured for TORO by Jodale Perry Corporation. 1. Safety instructions/Specifications..…………………………….2 2. Loose parts………………………………………………………3 3. Installation instructions…………….……………………………4 4.
PAGE 2
Safety Instructions Before Operating • • • • Read and understand the contents of this material before operating the vehicle. Become thoroughly familiar with the controls, capabilities and proper use of the equipment. Door kits fit all Workman® Heavy-Duty series cabs DO NOT weld, cut, drill, or modify door structure in any way. Always use safety belts.
PAGE 3
LOOSE PARTS LIST QTY Description 2 Ball stud 2 Gas shock 4 Safety clips 6 Brass washers 3
PAGE 4
Installation Instructions 1. Install brass washers on all 6 door pins. See Figure 1. Install brass washers on door pins Figure 1 2. Install ball studs into tabs provided in cab frame. Figure 2. Door ball stud Figure 2 3. Install doors on cab by door pins with the hinge part of the door. Figure 3.
PAGE 5
Installation Instructions 4. Install the door air shock onto ball stud in door as shown in Figure 4. Then install other end of air shock on to cab ball stud. Air shock Safety clips 5. 6. After installing air shocks, install safety clips on both sides of the ball stud receivers, See Figure 4, to ensure that the air shocks do not fall off. Figure 4. Loosen striker pin on cab and gently close the door and see where the striker pin should be located to keep the door closed tight. Figure 5.
PAGE 6