Installation Instructions

ManualsBrandsToro ManualsAttachmentsHitch Frame Kit, Workman HD/HDX/HDX-D Utility Vehicle

FormNo.3361-381RevA

HitchFrameKit

forWorkmanHD/HDX/HDX-DSeriesUtilityVehicle

ModelNo.07377—SerialNo.290000001andUp

InstallationInstructions

Safety

SafetyandInstructional

Decals

Safetydecalsandinstructionsareeasily

visibletotheoperatorandarelocated

nearanyareaofpotentialdanger.

Replaceanydecalthatisdamagedor

lost.

115-2047

1.Warning—donottouchthehotsurface.

Installation

1.Ifa2/3orFullSizeBedisinstalledonvehicle,it

mustberemovedasfollows:

A.Withbedlowered,removeclevispinsandlynch

pinssecuringeachcylinderrodendtobed

mountingplates(Figure1).

Figure1

2/3BedShown

1.Bedmountingplate

3.Clevispin

2.Cylinderrodend

4.Lynchpin

B.Removeclevispinandtwolynchpinssecuring

eachsetofpivotplatestoframechannels

(Figure2).

Figure2

FullBedShown

1.Vehicleframechannel3.Clevispin

2.Pivotplate4.Lynchpin

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3361-381 Rev A Hitch Frame Kit for Workman HD/HDX/HDX-D Series Utility Vehicle Model No. 07377—Serial No. 290000001 and Up Installation Instructions Safety Installation Safety and Instructional Decals 1. If a 2/3 or Full Size Bed is installed on vehicle, it must be removed as follows: Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. A.
PAGE 2
C. Carefully remove the bed from the vehicle. 5. Loosely secure an attachment bracket to each engine frame mounting bracket and vehicle frame with two flange head capscrews and flange locknuts previously removed (Figure 4). The full bed weighs approximately 325 lb (147.5 kg), so do not try to install or remove it by yourself. Use an overhead hoist or get the help of two or three other people. 6.
PAGE 3
Figure 7 Full Bed Shown 1. Left rear corner of bed Figure 10 Full Bed Shown 2. Pivot bracket 10. Loosely mount each set of new rear pivot plates to right and left bed frame channels with three 3/8 x 3-3/4 inch large capscrews and locknuts (Figure 8). Position brackets rearward on full bed as shown in Figure 8, and forward on 2/3 bed as shown in Figure 9. Figure 8 Full Bed Shown 1. Left rear corner of bed 2. Pivot bracket Figure 9 2/3 Bed Shown 1. Left rear corner of bed 2. Pivot bracket 11.
PAGE 4
Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).